Razdelilnik vžiga YN30V00057F2 za bager Kobelco SK330-6E SK330LC-6 SK330-6

SK330‑6E SK330LC‑6 SK330‑6 Control Valve Assy for Kobelco Excavator spare parts YN30V00057F2 Distribution Valve Assembly OEM

Product Overview

An operator who moves from a 20‑ton machine to a 33‑ton one notices two things: the reach, and how much the machine punishes imprecision. The SK330s — ‑6E, LC‑6 and ‑6 — are heavy machines, and their distribution valve, reference YN30V00057F2, is what decides whether that weight is controllable or merely large. It divides pump flow among boom, arm, bucket, swing and travel, so the operator's lever input translates into movement with the timing the machine was designed around.

When the block wears, that timing slips. The boom sags on a held bucket and the load is re‑spotted. The arm loses bite at the bottom of a cut. Swing lands short, so a second input is needed. Travel bogs on the ramp. On a big machine each one feels like fighting the levers, and all of it comes from oil crossing between circuits past worn spools. This OEM‑grade assembly replaces the block complete with fresh internals set to Kobelco platform values, so the worn unit comes off and the replacement fits the original port positions.

Core Advantages

1. Makes a 33‑ton machine feel controllable again
Restored metering means lever input becomes movement on the timing the operator expects, instead of needing correction after every stroke.

2. Loads hold through a truck cycle
A sagging boom forces a re‑spot on every pass. Renewed retention keeps the bucket where it was placed while the body fills.

3. Bite returns at the bottom of a cut
Leakage drains arm pressure before it reaches the cylinder. Fresh clearances put force back where the digging is decided.

4. Swing placement lands on the first attempt
Restored circuit isolation ends the overshoot‑and‑hunt habit that costs seconds each time the house moves.

5. Complete assembly rather than one circuit at a time
Where several circuits have drifted, one tested block resolves them together instead of repeated workshop visits.

Manufacturing & Quality Control

Spool and bore pairs are machined to print tolerance, matched by size, and hand‑run‑in until full‑stroke movement is smooth without binding. Assembled blocks are flow‑tested circuit by circuit with relief and compensator values recorded against platform figures; out‑of‑window units are stripped and corrected. Blocks ship internally oil‑fogged, ports capped, and crated on foam.

Frequently Asked Questions

Q1: Does this fit both the standard and long‑undercarriage versions?
A: The ‑6E, LC‑6 and ‑6 designations share the platform, but trim and some porting differ by build. Send the serial plate and existing valve tag and we confirm before dispatch.

Q2: What symptoms indicate valve wear?
A: Boom drift on held loads, lost arm force at the bottom of a cut, inconsistent swing placement, and travel that reacts to bucket load. A circuit leak test confirms.

Q3: Can my existing block be rebuilt?
A: If the casting is sound and has never been rebuilt, a kit may restore it. Where several circuits leak, a complete assembly usually gives better service per dollar. Photos help us judge.

Q4: What hydraulic servicing accompanies installation?
A: Flush the system, renew the return filter, clean the suction strainer, and refill with specified oil. Contaminated oil will damage new clearances quickly.

Q5: How much downtime should be planned?
A: Most of a working day for removal and refit with the cover open on a 33‑ton machine, plus bleeding and pressure verification before production resumes.

Q6: What is excluded from warranty?
A: Material and assembly faults are covered. Damage from dirty oil, water ingress, a spool forced against a bind, or reliefs altered outside specification is not. Photograph the crate before opening if damage is visible.